this post was submitted on 27 Feb 2024
82 points (97.7% liked)
Cars - For Car Enthusiasts
3811 readers
3 users here now
About Community
c/Cars is the largest automotive enthusiast community on Lemmy and the fediverse. We're your central hub for vehicle-related discussion, industry news, reviews, projects, DIY guides, advice, stories, and more.
Rules
- Stay respectful to the community, hold civil discussions, even when others hold opinions that may differ from yours.
- This is not an NSFW community, and any such content will not be tolerated.
- Policy, not politics! Policy discussions revolve around the concept; political discussions revolve around the individual, party, association, etc. We only allow POLICY discussions and political discussions should go to c/politics.
- Must be related to cars, anything that does not have connection to cars will be considered spam/irrelevant and is subject to removal.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Sure, the Versa is a crummy, low trim model. But look at what you get in the Versa compared to the Pontiac despite that:
The list goes on I'm sure. It costs more because you get so much more stuff, a lot of which is for safety.
Yeah, these older cars went slower and were death traps. The passenger cabin was the "crumple zone". People went flying through the windshield in a crash that would be easily survivable by the 80s.
On top of that, the odometer only went to 99,999 before resetting. Implying they didn't intend the vehicles to last much longer than 100k miles.
And you had to do more service more often such as tune ups for adjusting points ignition. And I think in some engines, adjusting valve lash since hydraulic lifters didn't become ubiquitous until later?
Yup, and king pins, suspension joints and pretty much every other moving part needed greasing constantly since sealed rubber boots, and tough plastics hadn’t been invented yet (let alone ball/spherical joints).
On the plus side, if you or kept up maintenance the joints would last a longer time, but back then the engines weren’t usually as reliable, and relied on leased gas to prevent detonation and valve wear. Now if a ball joint or wheel bearings fail, you just realize the whole assembly. So more waste, but less maintenance.
At least it was safety glass (mandated in 1937). Yeah old cars are terrifying. Cool but terrifying.